Perler bead melt ammount?

Deleted Account 2/19/2020 11:13 am 798

I've always wondered, should I melt the beads until they're flat? or just enough that they don't fall apart?raccoon

1 Replies

Sorry, you are unable to reply. If the thread is still open, you might have been blocked from commenting due to spam or abuse, or we might not have been able to verify that you are a real account. Try updating your profile and interacting more on the site. There are greater restrictions on forum comments due to spam. Spam comments will still not be published, even for verified accounts
Please log in to comment
Feb 26, 2020 5:40 pm

Hi! For singles, I iron almost to the point where all the holes are closed. That way they don't lose pieces or fall off while dancing and such! For bigger ones, I do almost a full-flat melt because again, it would be tragic of they broke >,< Hope that helps a little bit!


hklove