Bented pegboards

Scitty 8/4/2022 09:57 am 135

Hii! I usually have a problem with my perler pegboards which is that after ironing the perlers, the pegboards bent on their own, like if the heat is doing it. Is this happening to anyone else? Is there a way too avoid this? Thanks! (sorry if my english is bad, it's not my first language).



7 Replies

Please log in to comment
Displaying 1-7 of 7 comments
Sort by:
Aug 16, 2022 6:44 pm

@Scitty: ofc!! i'm glad i could help!! awesome1

Aug 16, 2022 5:46 pm

i use the semi-painstaking method of transfering the pattern onto masking tape before ironing! it's kinda annoying but it preserves the boards and allows you to make a bunch of stuff with the same board and iron them all at once!

Aug 16, 2022 5:32 pm
@arefriendselectric: I will try it, thank you! : D
Aug 16, 2022 5:31 pm

@bugz_doez_kandi: Hi! I did this and it worked a lot better big grin thank u!

Aug 5, 2022 10:45 am

u could use the masking tape method!! basically, u make the perler on the perler board, then put masking tape over it and slowly peel it off so the beads stick to the tape. then u iron it on there instead of the board. i probably don't make a lot of sense 0__0 but u can look up sum yt tutorials!!

Aug 5, 2022 5:39 am

i have that same problem!! heat it up with a hair dryer or something of that like, and put a heavy object, like a large book on top of it.

  • 13Killz
Aug 5, 2022 2:49 am

id heat it up again and put a book on it after u use it (a heavy one)