how do you make a 3d kandi domo?

Deleted Account 12/9/2012 11:52 am 1587

3 Replies

Sorry, you are unable to reply. If the thread is still open, you might have been blocked from commenting due to spam or abuse, or we might not have been able to verify that you are a real account. Try updating your profile and interacting more on the site. There are greater restrictions on forum comments due to spam. Spam comments will still not be published, even for verified accounts

Please log in to comment

Displaying 1-3 of 3 comments

Sort by:

Date

SycoSquirl
Old School Member

Dec 9, 2012 7:49 pm

ahhh so there are 2 ways to do this. one is to make 5 or 6 pannels, one for the front, back, both sides, bottom and an optional open top flap or closed flap or no flap. Make each part separate but the same highight the the front and back need to be the same width along with the two sides. After that you make 4 small multi's and close off one end and attach them to the side pannels and bottom pannel. The other way is to make it as one big multi, so you wont have to worry about all the different pannels, you make it really big and leave room to make the bottom thick. You close off the bottom (or you can do the top as well) and then do the 4 smaller multis again and attach to the sides and bottom. Hope this helped (oh the panels are make using pyote stitch in case you didnt know)

kittehkandi
Guest

Dec 9, 2012 1:19 pm

here is an example

SycoSquirl
Old School Member

Dec 9, 2012 1:15 pm

could you post a picture example so we know exactly what your thinking of

You are in mobile-friendly mode, which is recommended for all devices, especially mobile devices. Turn on desktop mode.

Warning: Desktop mode is intended for mobile devices only and will not display correctly on desktop or laptop computers

how do you make a 3d kandi domo?

3 Replies

Login / Register

Active Threads

Random Pattern